Reagent reservoir
08 April, 2009 | Supplied by: Lomb Scientific (Aust) Pty Ltd
The V-shaped wells of the Scienceware 12 Channel Reagent Reservoir allow complete sample withdrawal and minimise the waste of reagents. Each channel holds up to 5 mL and is numbered to facilitate serial dilution.
Electrode management system
08 April, 2009 | Supplied by: Endress+Hauser Australia Pty Ltd
The Memobase electrode management system provides users insight into the reliability, performance, estimated lifetime and early-warning-failure of pH electrodes.
Permeable membrane cap
08 April, 2009 | Supplied by: SCHOTT Australia Pty Ltd
The Schott Duran permeable membrane cap can release gases to relieve pressure in a sealed bottle.
Electroporation electrodes
08 April, 2009 | Supplied by: SDR Scientific
The Platinum Tweezertrode electrodes from BTX are designed to enhance in utero or in vivo transfection applications.
AM 2224 stepper motor
08 April, 2009 | Supplied by: ERNTEC Pty Ltd
The AM 2224 two-phase miniature stepper motor has a diameter of 22 mm and a high power-to-volume ratio. The motor achieves an output of 2.5 W and a peak holding torque of 45 mNm.
Vacuum pump
08 April, 2009 | Supplied by: PIAB Vacuum Technologies
The P6040 vacuum pump range with COAX technology provides flexible mounting options, an extensive performance range and optional control functions, making it very adaptable and suitable for most industrial vacuum applications.
Sterile valve connections
08 April, 2009 | Supplied by: FlowTherm Australia Pty Ltd
Colder Products Company has released the Steam-Thru II Connections, which provides a sterile connection between disposable systems and existing stainless steel processing equipment.
Buccal swabs
08 April, 2009 | Supplied by: VWR International Pty Ltd
The nylon flocked buccal swabs from MicroRheologics are suitable for applications where the sample size is particularly small or where increased sensitivity is required.
Flow analysers
08 April, 2009 | Supplied by: ALPE Pty Ltd
The Futura flow analysers reach very low detection limits, while still extending the reporting ranges of results and speeding up the operation by reducing the number of dilutions.
LabServ Microcentrifuge
08 April, 2009 | Supplied by: Thermo Fisher Scientific
The LabServ Microcentrifuge (LBS7510) spins up to 2200 x g and holds 6 x 2 mL/1.5 mL tubes. It comes equipped with adapters for 0.5 mL tubes as well as an interchangeable rotor for 2 x 8-strip PCR tubes (0.2 mL).
Sub-visible particle analyser
08 April, 2009 | Supplied by: Crea Laboratory Technologies Pty Ltd
The Pamas SVSS is a laboratory particle counter for the measurement of particulates in liquids. The counter can be used for many fluid applications where particle quantifying and particle size from 1 µm upwards is important.
Gas sample cylinder
08 April, 2009 | Supplied by: Duff & Macintosh
Sentry’s sample cylinder allows gas samples to be collected at pressure, assuring that the sample constituents that can change state with pressure reduction are not lost during sample collection. An example of this type of sample would be LPG or other two-phase fluids that could flash off sample constituents if the pressure was reduced.
Nanoparticle tracking
08 April, 2009 | Supplied by: Particle & Surface Sciences Pty Ltd
The Nanoparticle Tracking Analysis system from NanoSight Techology is based on laser light scattering microscopy. The instruments can visualise and dynamically size populations of particles in a liquid on an individual basis in the particle size range of 10-1000 nm, dependent on material.
Microcentrifuge
08 April, 2009 | Supplied by: Eppendorf South Pacific Pty Ltd
The 30-place microcentrifuge 5430 line provides a range of options, including eight different rotors, tubes from 0.2 to 50 mL, microtest plates, deepwell plates and slides.
Water activity meter
08 April, 2009 | Supplied by: Graintec Pty Ltd
The Aqualab Series 4 water activity meter features an intuitive menu navigation, easy-to-clean sensor area and data storage to provide high functionality and utility for operators.
